25/05/2023 02:02:58

Wiper Arm - RH (RHD) (Remove and Replace)

Correction code 175098020.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 1058696-00-A Wiper Arm Removal Tool

Remove

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Remove the LH wiper arm nut cover.
  3. Release the clip that attaches the LH wiper arm hose to the vehicle.
  4. Release the LH wiper arm hose from the Y-tube.
  5. Remove the nut that attaches the LH wiper arm to the wiper motor assembly.
    Tip: Use of the following tool(s) is recommended:
    • 15 mm socket
    • 3/8 in std ratchet
    • 3/8 in torque wrench (installation only)
  6. Place the base of the wiper arm removal tool under the wiper arm and position the set screw so that it is centered and touching the wiper arm stud, and then tighten the set screw until the wiper arm is released.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Removing the wiper arm without the wiper arm removal tool can result in damage to the wiper arm or wiper motor.
  7. Remove the wiper arm and hose assembly from the vehicle.
  8. Repeat step 2 through step 7 for the RH wiper arm and hose assembly.

Install

  1. Position the RH wiper arm onto the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure the RH wiper tip is aligned between the two indicators at the corner of the windshield.
  2. Install the nut that attaches the RH wiper arm to the wiper motor assembly.
    25 Nm (18.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 15 mm socket
    • 3/8 in std ratchet
    • 3/8 in torque wrench (installation only)
  3. Connect the RH wiper arm hose to the Y-tube, and then install the hose clip.
  4. Install the RH wiper arm nut cover.
  5. Repeat steps 1 through 4 for the LH wiper arm and hose assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure to route the LH wiper arm hose under the wiper arm pivot joint.
    Figure 1. Correct hose routing
  6. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).