2025-03-31
Breather - Rear Drive Unit (Remove and Replace)
Correction code
40305402
2.10
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
- 2025-03-31: Added step to refer to the suspension alignment tables to define whether an alignment check is required and, if so, what type of alignment check is required.
Remove
- Remove the rear subframe assembly. See Subframe Assembly - Rear (Remove and Install).
-
Remove the breather from the rear drive unit.
Install
-
Install the breather onto the rear drive unit.
5 Nm (3.7 lbs-ft)
- Install the rear subframe assembly. See Subframe Assembly - Rear (Remove and Install).
- Since the subframe was removed and reinstalled: Refer to the Alignment Requirement tables to determine whether an EPAS alignment check (EC) or four wheel alignment check (AC) is necessary. If performed, add the alignment check/adjust as a separate activity. See Alignment Requirement - Suspension.