2025-02-07

Ball Stud - Liftgate - Body Side - Pair (Remove and Replace)

Correction code 11335052 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2025-02-07: Corrected procedure to show body side liftgate ball studs rather than liftgate side ball studs.
  • 2025-02-06: Released new procedure.

Remove

  1. Open the liftgate.
  2. Use a telescopic stand to support the liftgate.
    Informational PurposesAn informational icon, calling your attention
    Note
    Put a towel in between the stand and the liftgate to prevent damage to the liftgate trim.
  3. Disconnect 12V/LV power. See 12V/LV Power (Disconnect and Connect).
  4. Release the liftgate assist strut from the body side ball stud.
  5. Release the liftgate power strut from the body side ball stud.
  6. Remove the LH and RH liftgate strut body side ball stud from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 13 mm deep socket
    Figure 1. LH side shown, RH side similar

Install

  1. Apply Loctite 243 on the threads of the new body side liftgate ball studs, and then install the ball studs to the vehicle.
    24 Nm (17.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 13 mm deep socket
    Figure 2. LH side shown, RH side similar
  2. Apply tape around the LH and RH liftgate strut body ball studs.
    Informational PurposesAn informational icon, calling your attention
    Note
    Cut a 20mm diameter hole to a piece of masking tape min. 3 cm wide and 10 cm in length. Draw the hole with the aid of a socket with 20mm external diameter.
    Figure 3. LH side shown, RH side similar
  3. Clean the LH and RH body side ball studs with IPA wipes. Allow 1 minute to dry.
  4. Apply 2 layers of touch up paint to the LH and RH body side ball studs. Do not apply paint to the ball end.
    Informational PurposesAn informational icon, calling your attention
    Note
    Allow the first coat of paint to dry for 20 minutes before applying the second coat.
  5. Remove masking tape from around LH and RH body side ball studs.
  6. Install assist and power struts onto the body side ball studs.
  7. Remove the liftgate support stand.
  8. Connect 12V/LV power. See 12V/LV Power (Disconnect and Connect).
  9. Close the liftgate.