05/06/2023 20:43:22

Switch - Window - Driver (Remove and Replace) (RHD)

Correction code 115064020.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the RH front door and fully lower the RH front window.
  2. Remove the bolt that attaches the middle bolt cover to the RH front door trim panel.
    6 Nm (4.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T30 socket
    • 6 in extension
    • Cordless Ratchet/Impact Driver
    • Ratchet/torque wrench
  3. Release the clips that attach the middle bolt cover to the RH front door trim panel, and then remove the cover from the door trim panel.
  4. Remove the clips that attach the LED light to the trim panel.
  5. Release the tabs that attach the driver window switch to the RH front door trim panel.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Replace door trim if any tabs are broken during removal.
  6. Release the window switch electrical harness from the harness clip, and then disconnect the electrical connector.

Install

  1. Fasten the window switch electrical harness to the harness clip, and then connect the electrical connector.
  2. Fasten the tabs that attach the driver window switch to the RH front door trim panel.
  3. Install the clips that attach the LED light to the trim panel.
  4. Fasten the clips that attach the middle bolt cover to the RH front door trim panel, and then install the cover from the door trim panel.
  5. Install the bolt that attaches the middle bolt cover to the RH front door trim panel.
    6 Nm (4.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T30 socket
    • 6 in extension
    • Cordless Ratchet/Impact Driver
    • Ratchet/torque wrench
  6. Close the RH front door and fully lower the RH front window.