2026-02-11

Flood Ports - 2nd Generation (Remove and Replace)

Correction code 16102702 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2023-06-16: Replaced steps for Toolbox 3 Tools tab.
  • 2024-06-17 Deleted ancillary bay air leak test.

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Remove the rear HV battery skid plate. See Skid Plate - HV Battery - Rear (Remove and Replace).
  3. Release clips securing coolant hoses to LH and RH shear plate.
  4. Remove the 2nd generation flood ports from the LH and RH underside of the HV battery ancillary bay.
    Informational PurposesAn informational icon, calling your attention
    Note
    Twist the flood ports while pulling down.

Install

  1. Use an IPA wipe to clean the area around the openings where the flood ports were removed.
  2. Install clips securing coolant hoses to LH and RH shear plate.
  3. Install the 2nd generation flood ports into the openings at the LH and RH underside of the HV battery ancillary bay.
    Informational PurposesAn informational icon, calling your attention
    Note
    Press up firmly to fully seat the flood ports and fasten the clips (x8) internally.
  4. Install the rear HV battery skid plate. See Skid Plate - HV Battery - Rear (Remove and Replace).
  5. Install the mid aero shield panel. See Panel - Aero Shield - Rear (Remove and Replace).
  6. Add the ancillary bay air leak test as a separate activity if necessary. See Ancillary Bay Air Leak Test.
    Informational PurposesAn informational icon, calling your attention
    Note
    Add correction code 16100400 as needed.