2022-10-17
Trim - B-Pillar - Lower - LH (Structural Pack) (Remove and Replace)
Correction code
15183412
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
- Open the LH front door.
- Move the driver seat forward.
- Remove the LH mid A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
- Remove the LH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
- Release the front portion of the 2nd row lower seat cushion.
- Release the clips (x2) that attach the front of the LH lower C-pillar trim to the vehicle, and then release the front edge of the trim.
-
Remove the clips (x8) that attach the LH lower B-pillar trim to the vehicle, and then remove the trim from the vehicle.
TIpStart by releasing the top edges of the trim, and then continue to release the remaining clips.
Install
-
Position the LH lower B-pillar trim into the vehicle, and then secure the clips that attach the trim to the vehicle.
NoteVerify the top edges are seated properly and seals are positioned correctly.
-
Secure the clips (x2) that attach the front of the LH lower C-pillar trim to the vehicle.
NoteVerify the seal is in the correct position.
- Secure the front of the 2nd row lower seat cushion.
- Install the LH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
- Install the LH mid A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
- Move the driver seat to the original position.
- Close the LH front door.