2023-07-27

Mount - Front Drive Unit - LH (Remove and Replace)

Correction code 39012600 3.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2023-07-26: Reorganized the procedure.

Remove

  1. Remove the front subframe assembly. See Subframe Assembly - Front (Dual Motor) (Remove and Install).
  2. Remove the clips (x2) that attach the front drive unit harness to the front drive unit inverter.
  3. Remove the bolts (x3) that attach the front drive unit LH mount to the front drive unit.
    35 Nm (25.8 lbs-ft) + 55 degrees
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Ratchet/torque wrench
    • External Torx E14

Install

  1. Install the bolts (x3) that attach the front drive unit LH mount to the front drive unit.
    35 Nm (25.8 lbs-ft) + 55 degrees
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torque wrench with angle measurement
    • External Torx E14
  2. Install the clips (x2) that attach the front drive unit harness to the front drive unit inverter.
  3. Install the front subframe assembly. See Subframe Assembly - Front (Dual Motor) (Remove and Install).
  4. Refer to the Alignment Requirement tables to determine whether an EPAS alignment check (EC) or four wheel alignment check (AC) is necessary. If performed, add the alignment check/adjust as a separate activity. See Alignment Requirement - Suspension.