2025-03-13

Bolt - Steering Wheel to Upper Column (Remove and Replace)

Correction code 32051842 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2025-03-13: Released new procedure to support Toolbox article 8743800 on steering column lateral play.

Remove

  1. Remove the driver airbag. See Airbag - Driver (Remove and Replace).
  2. Remove and discard the bolt that attaches the steering wheel to the steering column.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm hex
    • 3/8 in std ratchet
    • 3/8 in flex head torque wrench (installation only)
    • 3 in extension

Install

  1. Install a new bolt (1036655-00-A) that attaches the steering wheel to the steering column.
    80 Nm (59.0 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm hex
    • 3/8 in std ratchet
    • 3/8 in flex head torque wrench (installation only)
    • 3 in extension
  2. Install the driver airbag. See Airbag - Driver (Remove and Replace).