Bracket - Harness - Sill Panel - Front - LH (Remove and Replace)
Correction code
15180152
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
Remove
- Remove the lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
- Release the bottom of the front door seal from the body of the vehicle.
-
Use a clip prytool to release the clips that attach the front seat harness to the front sill panel harness bracket.
-
Release the clips that attach the front sill panel harness bracket to the body of the vehicle.
Install
Installation procedure is the reverse of removal, except for the following: