2020-05-27
Bracket - Center - Cowl Screen (Remove and Replace)
Correction code
12252102
0.24
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Bolt that attaches the cowl screen center bracket to the vehicle |
![]() 4 Nm (2.9 lbs-ft) |
|
Reuse |
Remove
- Open the LH front door and fully lower the window.
- Remove the cowl screen panel. See Panel - Cowl Screen (Remove and Replace).
-
Remove the center bolt that
attaches the center cowl screen bracket to the vehicle, and then remove the
bracket from the vehicle.
NoteUse of the following tool(s) is recommended:
- 10 mm socket
- Flex head ratchet/flex head torque wrench
Install
-
Position the cowl screen
center bracket into the vehicle, and then install the bolt that attaches the
bracket to the vehicle.4 Nm (2.9 lbs-ft)NoteUse of the following tool(s) is recommended:
- 10 mm socket
- Flex head ratchet/flex head torque wrench
- Install the cowl screen panel. See Panel - Cowl Screen (Remove and Replace).
- Raise the LH front window.
-
Verify operation of the windshield washer and wipers.
NoteSpray windshield washer fluid onto the windshield. Perform two additional wipes, and then a third wipe a few seconds later.
- Close the LH front door.