05/03/2021 09:58:33

Sensor - Position - Seat Track - 2nd Row Seat - RH (Remove and Replace)

Correction code 13022602 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the RH doors and fully lower the RH windows.
  2. Move the passenger seat fully forward.
  3. Move the RH 2nd row seat to easy entry mode.
  4. Disconnect the RH 2nd row seat track position sensor electrical connector.
  5. Remove the bolt that attaches the RH 2nd row seat track position sensor to the seat assembly, and then remove the sensor from the assembly.
    1.5 Nm (1.1 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
    • Torque wrench with angle measurement
    • 2 in extension

Install

Installation procedure is the reverse of removal.