01/05/2020 14:09:41

Phone Tray - Center Console (Remove and Replace)

Correction code 15196402 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Phone Tray - Center Console (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws that attach the center console phone tray to the center console
1 Nm (.7 lbs-ft)
  • Torx T20 socket
  • 4 in extension
Reuse

Remove

  1. Open both the forward and rearward center console rotating lids.
  2. Remove and secure the customer's belongings from the phone tray, if needed.
  3. Remove the phone dock mat from the center console.
  4. Slide the phone tray bar to the left, and then remove the bar from the phone tray.
  5. Remove any cables from the center console phone tray routing, if installed, and then move the cables through the opening in the center console phone tray.
  6. Raise the center console phone tray to access the screws.
  7. Remove the screws that attach the center console phone tray to the center console.
    1 Nm (.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
    • 4 in extension
  8. Release the clips (x5) that attach the center console phone tray to the center console, and remove the tray from the vehicle.

Install

Installation procedure is the reverse of removal, except for the following:

Informational PurposesAn informational icon, calling your attention
Note
Make sure the magnet and the felt tape holding the magnet have not moved out of place before installation.