17/05/2023 01:05:15

Quad Camera Cover - Upper (Remove and Replace) (RHD)

Correction code 15053702 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the lower quad camera cover. See Quad Camera Cover - Lower (Remove and Replace).
  2. Remove the rear view mirror. See Mirror - Rear View (Remove and Replace).
  3. Release the clips that attach the upper quad camera cover, disconnect the interior camera connector, and then remove the upper quad camera cover and interior camera assembly from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not pull the upper quad camera cover with excessive force, as the electrical harness is still attached to the interior camera.
  4. Remove the screws that attach the interior camera to the upper quad camera cover, and then remove the interior camera from the upper quad camera cover.

Install

  1. Position the interior camera onto the upper quad camera cover, and then install the screws that attach the interior camera onto the upper quad camera cover.
    1 Nm (.7 lbs-ft)
  2. Connect the interior camera connector, and then install the clips that attach the upper quad camera cover to the vehicle.
  3. Install the rear view mirror. See Mirror - Rear View (Remove and Replace).
  4. Install the lower quad camera cover. See Quad Camera Cover - Lower (Remove and Replace).