24/08/2022 12:23:54

Antenna - MIMO (Remove and Replace)

Correction code 21331102 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Antenna - MIMO (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the MIMO antenna to the body
10 Nm (7.4 lbs-ft)
  • Torx Plus IP30 socket
 Reuse

Remove

  1. Open the LH front door and fully lower the LH front window.
  2. Remove the LH mid A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  3. Remove the upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove and Replace).
  4. Remove the driver sun visor. See Sun Visor - LH (Remove and Replace).
  5. Remove the rear view mirror. See Mirror - Rear View (Remove and Replace).
  6. Repeat step 1 through step 4 for the RH side of the vehicle.
  7. With assitance, release the clips (x5) that attach the front edge of the front headliner.
    Informational PurposesAn informational icon, calling your attention
    Note
    Start from the front center of the front headliner.
  8. Release the connector locks, and then disconnect the MIMO antenna electrical connectors.
  9. Remove the bolt that attaches the MIMO antenna to the body.
    10 Nm (7.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    The bolt is captive in the antenna housing and cannot be removed from the housing.
    Tip: Use of the following tool(s) is recommended:
    • Torx Plus IP30 socket
  10. Release the clips that attach the MIMO antenna to the body, and then remove the it from the vehicle.

Install

Installation procedure is the reverse of removal except for the following:
  • On the vehicle touchscreen, verify the Bluetooth, Wifi, and LTE are functioning properly.