Seal - Perimeter - HV Battery (Remove and Replace)
Correction code 16103002 3.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
Remove
- Remove the HV battery. See HV Battery (AWD) (Non-Structural Pack) (Remove and Install).
-
Remove and discard the HV
battery perimeter seal.
Figure 1. Ancillary Bay Type
Install
-
Install the ancillary bay
perimeter seal onto the HV battery.
- Install the HV battery. See HV Battery (AWD) (Non-Structural Pack) (Remove and Install).