2022-09-15

Wheel Arch Liner - Rear - LH (Structural Pack) (Remove and Replace)

Correction code 12011112 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the LH rear wheel. See Wheel Assembly (Remove and Install).
  2. Remove the push clips (x7), fan clips (x6) and metal clips (x4) that attach the LH rear wheel arch liner to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Rotate the fan clips counterclockwise to remove.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use a prytool to get cutters under metal clip.
  3. Release the LH rear wheel arch liner from the studs (x10), and then remove the liner from the vehicle.

Install

  1. Position the LH rear wheel arch liner into the vehicle and onto the studs (x10), tuck the liner behind the garnish, and then secure the mid flap over the liner.
  2. Install the push clips (x7), fan clips (x6) and metal clips (x4) that attach the LH rear wheel arch liner to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use a socket to press the metal clips evenly.
  3. Install the LH rear wheel. See Wheel Assembly (Remove and Install).