10/09/2024 00:36:18

Sensor - TPMS (Remove and Replace)

Correction code 34040202 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the wheel. See Wheel Assembly (Remove and Install).
  2. Place the wheel on the tire changer, with the outside of the wheel facing up.
  3. Insert the center clamp.
  4. Tighten the cone on the center clamp.
  5. Remove the valve core, and allow the tire to deflate.
  6. Position the upper bead roller at the edge of the rim.
  7. Rotate the tire to loosen the upper bead. Lubricate the bead as the tire rotates.
  8. Position the upper bead roller approximately 100 mm from the valve stem, and then compress the bead to expose the TPMS sensor.
  9. Remove the nut that attaches the TPMS sensor to the wheel, and then remove the TPMS sensor.

Install

  1. Use an IPA wipe to thoroughly clean the inside and outside of the TPMS sensor mounting hole.
  2. Install the TPMS sensor so that it fits closely to the wheel.
  3. Install the nut that secures the TPMS sensor to the wheel.
    8 Nm (5.9 lbs-ft)
  4. Release the upper bead roller, and allow the bead to seat against the wheel.
  5. Inflate the tire to seat the bead.
  6. Install the valve stem core, and then remove the wheel from the tire changer.
  7. Rebalance the wheel. See Tire - Front - LH (Balance).
  8. Reinstall the wheel. See Wheel Assembly (Remove and Install).
  9. Program the TPMS sensor ID. See TPMS (Sensor ID Drive Learn).