17/10/2022 10:00:23

Support - Carpet - LH (Structural Pack) (Remove and Replace)

Correction code 153063020.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the LH front door.
  2. Move the driver seat rearward.
  3. Remove the LH front floormat.
  4. Remove the LH mid A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  5. Remove the LH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
  6. Remove the LH center console side panel. See Side Panel - Center Console - LH (Remove and Replace).
  7. Remove the screw and push clips (x2) that attach the LH footwell cover to the vehicle.
    2.5 Nm (1.8 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • T20 socket
  8. Release the tabs (x3) that attach the LH footwell cover to the vehicle, disconnect the electrical connectors (x2), and then remove the cover from the vehicle.
  9. Release the clips (x3) that attach the LH cabin carpet to the LH carpet support.
    Tip: Insert a clip pry tool outboard of the clip, and then rotate to the right to release one side of clips. Move the clip pry tool inboard of the clip, and then rotate to left to fully release the carpet clip from the cabin support.
  10. Release the seat harness clip, route the harness away from the carpet, and then fold the LH front cabin carper rearward.
    Informational PurposesAn informational icon, calling your attention
    Note
    Maneuver the carpet under the brake and accelerator pedals.
  11. Remove the clips (x3) that attach the LH carpet support to the vehicle, and then remove the support from the vehicle.

Install

  1. Position the LH carpet support into the vehicle, and then install the clips (x3) that attach the support to the vehicle.
  2. Fold the LH front cabin carpet back to the original position, maneuver the seat harness into position, and then install the clip.
    Informational PurposesAn informational icon, calling your attention
    Note
    Maneuver the carpet under the brake and accelerator pedals.
  3. Install the clips (x3) that attach the LH cabin carpet to the LH carpet support.
    Informational PurposesAn informational icon, calling your attention
    Note
    Secure the vertical clip into place first. Verify fitment of carpet
  4. Position the LH footwell cover into the vehicle, connect the electrical connectors (x2), and then secure the tabs (x3) that attach the cover to the vehicle.
  5. Install the screw and push clips (x2) that attach the LH footwell cover to the vehicle.
    2.5 Nm (1.8 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • T20 socket
  6. Install the LH center console side panel. See Side Panel - Center Console - LH (Remove and Replace).
  7. Install the LH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
  8. Install the LH mid A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  9. Install the LH front floormat.
  10. Move the driver seat to the original position.
  11. Close the LH front door.