05/03/2020 11:07:38

Hood - Triple Camera (Remove and Replace)

Correction code 15051302 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the lower quad camera cover. See Quad Camera Cover - Lower (Remove and Replace).
  2. Remove the rear view mirror. See Mirror - Rear View (Remove and Replace).
  3. Release the clips that attach the upper quad camera cover, disconnect the interior camera connector, and then remove the upper quad camera cover and interior camera assembly from the vehicle.
  4. Release the clips that attach the triple camera hood to the windshield bracket, and then remove the hood from the vehicle.

Install

  1. Use glass cleaner and a clean towel to thoroughly clean the windshield area in front of the camera.
  2. Use the alignment pins to place the triple camera hood in the correct location on the windshield bracket.
  3. Install the clips (x2) that attach the triple camera hood to the windshield bracket.
  4. Connect the interior camera connector, and then install the clips that attach the upper quad camera cover to the vehicle.
  5. Install the rear view mirror. See Mirror - Rear View (Remove and Replace).
  6. Install the lower quad camera cover. See Quad Camera Cover - Lower (Remove and Replace).