26/03/2020 16:41:04

Assembly - Rear Vent - Center Console (Remove and Replace)

Correction code 15190702 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Move the driver seat and front passenger seat forward.
  2. Use a plastic trim tool to release the clips (x4) that attach the center console rear vent assembly to the center console, and then separate the rear vent assembly from the center console.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    The rear vent assembly is still attached by an electrical connector.
  3. Disconnect the electrical harness from the center console rear USB hub connector, and then remove the center console rear vent assembly from the vehicle.

Install

Installation procedure is the reverse of removal.