07/04/2022 16:21:37

Camera - Triple - Forward Facing (Remove and Replace)

Correction code 17231002 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Camera - Triple - Forward Facing (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Forward facing camera assembly to windshield bracket screws
1 Nm (.7 lbs-ft)
  • Torx T10 blade attachment
  • Wiha torque setter
  • Wiha TorqueVario-S 0.8 Nm - 2.0 Nm screwdriver (installation only)
Reuse

Remove

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Whenever a camera has been moved out of its original position (for example, a camera or windshield replacement), camera calibration data must be cleared using the vehicle touchscreen: Controls > Service > Camera Calibration > Clear Calibration.
  1. Remove the rear view mirror. See Mirror - Rear View (Remove and Replace).
  2. Release the clips that attach the upper quad camera cover to the windshield bracket, and then separate the cover from the bracket.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Carefully release the cover from the windshield bracket, as an electrical harness is still attached.
  3. Disconnect the electrical harness from the occupant camera on the inside of the upper quad camera cover, and then remove the camera cover from the vehicle.
  4. Remove the triple camera hood. See Hood - Triple Camera (Remove and Replace).
  5. Remove the screws (x4) that attach the forward facing camera to the windshield bracket.
  6. Disconnect the electrical harness from the forward facing camera connectors.
  7. Remove the forward facing camera from the vehicle.
    Tip: Rotate the electrical connectors to the side to allow better grip of the forward facing camera.

Install

  1. Clean the inner windshield camera viewing area with a clean microfiber cloth and glass cleaner. Let the windshield fully dry before continuing.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Verify that the windshield has no stains or leftover residue. Otherwise, Autopilot features may be hindered.
  2. Install the forward facing camera to the windshield bracket, and then connect the electrical harness to the camera connectors.
  3. Install the screws (x4) that attach the forward facing camera to the windshield bracket.
    1 Nm (.7 lbs-ft)
  4. Install the triple camera hood. See Hood - Triple Camera (Remove and Replace).
  5. Bring the upper quad camera cover to the windshield bracket, and then connect the electrical harness to the occupant camera on the inside of the cover.
  6. Fasten the clips that attach the upper quad camera cover to the windshield bracket.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure that the connector for the rear view mirror passes through the opening in the upper quad camera cover.
  7. Install the rear view mirror. See Mirror - Rear View (Remove and Replace).
  8. Adjust the forward facing camera. See Camera - Forward Facing (Pitch Verification).