2025-09-12

Closeout Panel - Door - Rear - LH (Remove and Replace)

Correction code 11701402 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Closeout Panel - Door - Rear - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes

Screws that attach the window motor to the closeout panel

Screws that attach the rear window regulator to the closeout panel

3.5 Nm (2.6 lbs-ft)
  • Torx T25 socket
Reuse

Remove

  1. Remove the LH rear door closeout panel assembly. See Closeout Panel - Door - Rear - LH (Remove and Install).
  2. Remove the screws that attach the LH rear window motor to the closeout panel, and then remove the motor from the panel.
    3.5 Nm (2.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket
  3. Remove the screws that attach the rear window regulator to the closeout panel, and then release the window regulator mechanism from the closeout panel dowels.
    3.5 Nm (2.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket

Install

Installation procedure is the reverse of removal.