Skid Plate - HV Battery - Front (Remove and Replace)
Correction code
16102002
0.36
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
- 2025-07-01: Added torque spec for non-e-coated skid plate.
Remove
- Remove the front aero shield. See Panel - Aero Shield - Front (Non-Structural Pack) (Remove and Replace).
-
Remove the clip and bolt
that attaches the front of the LH and RH front wheel liner to the HV
battery.5 Nm (3.7 lbs-ft)TIpUse of the following tool(s) is recommended:
- 10mm socket
- 4 in extensio
-
Remove the bolts and clips
that attach the skid plate to the battery, and then remove the plate from
the battery.
NoteThere are two different skid plates, each with different fastener torque specs.Black skid plate (e-coated)13 Nm (9.6 lbs-ft)Silver skid plate (not e-coated)17 Nm (12.5 lbs-ft)TIpUse of the following tool(s) is recommended:
- EP10 socket
- 4 in extension
Install
Installation procedure is the reverse of removal.