Vehicle Configuration Badge (Remove and Replace)
Correction code
12050602
0.18
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
- 1557459-00-A MY Badge Location Fixture DM
- 1453028-00-A KIT, BADGE REMOVAL
- 1465974-00-A TOOL, PRESSURE ROLLER
Remove
- Cut a piece of fishing line about 24 in. in length.
-
Tie a slip knot at one end of the
fishing line and attach it to the center groove of one of the handles in the badge
removal kit. Repeat this step for the other end of the fishing line and second
handle.
-
Insert the fishing line between the
vehicle configuration badge and the liftgate, and then move the line in a sawing motion
to separate the badge from the liftgate.
Install
-
Use IPA wipes to clean all adhesive
residue and debris from the surface.
NoteAllow 1 minute of dry time.
- Open the liftgate partially.
-
Position the badge jig onto the RH
rear of the liftgate, and then use masking tape to secure the jig to the liftgate.
-
Slowly peel vehicle configuration
badge backing, position the badge onto the jig alignment pins, and then press the badge
onto the liftgate.
-
Remove the plastic cover from the
badge, but do not discard the plastic cover yet.
- Remove the jig from the vehicle.
-
Place the plastic cover over the badge
for protection.
-
Wet out the badge adhesive.
- Remove the plastic cover from the badge.
- Close the liftgate.
- Clean the work area.