2021-11-18

NVH Pad - Glove Box (Remove and Replace)

Correction code 14051302 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open all doors and fully lower all windows.
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
  4. Remove the LH and RH instrument panel end caps. See End Cap - Instrument Panel - LH (Remove and Replace).
  5. Remove the LH and RH air wave bezel caps. See End Cap - Air Wave - LH (Remove and Replace).
  6. Remove the main instrument panel decor trim. See Decor Trim - Instrument Panel - Main (Remove and Replace).
  7. Remove the front passenger knee airbag. See Airbag - Knee - Front Passenger (Remove and Replace).
  8. Remove the glove box. See Glove Box - With Knee Airbags (Remove and Replace).
  9. Peel the NVH pad from the glove box.
  10. Use IPA wipes to remove remaining adhesive residue from the glove box, and then allow one minute for the IPA to dry.

Install

  1. Install a new NVH pad onto the glove box assembly.
  2. Install the glove box. See Glove Box - With Knee Airbags (Remove and Replace).
  3. Install the front passenger knee airbag. See Airbag - Knee - Front Passenger (Remove and Replace).
  4. Install the main instrument panel decor trim. See Decor Trim - Instrument Panel - Main (Remove and Replace).
  5. Install the LH and RH air wave bezel caps. See End Cap - Air Wave - LH (Remove and Replace).
  6. Install the LH and RH instrument panel end caps. See End Cap - Instrument Panel - LH (Remove and Replace).
  7. Connect 12V power. See 12V/LV Power (Disconnect and Connect).
  8. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  9. Close all doors and raise all windows.