24/07/2023 17:30:40
Sensor - Resistive Occupancy - Front Seat - RH (Remove and Replace)
Correction code 20202202 0.78 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Remove
- Remove the passenger seat cushion trim. See Trim - Cushion - Driver Seat (Remove and Replace).
-
While wearing cut-resistant gloves, carefully use a razor blade to separate the resistive occupancy sensor from the passenger seat cushion foam.
WarningAlways wear cut-resistant gloves when using cutting tools.CAUTIONTake care not to damage the sensor harness, seat trim, or other surrounding components with the razor blade.CAUTIONTake care to remove as little foam as possible.
-
From the underside of the cushion, carefully route the resistive occupancy sensor harness up through the top of the cushion, and then remove the sensor from the cushion.
CAUTIONWhile removing the harness, take care not to damage the foam.
Install
-
Position the resistive occupancy sensor on top of the passenger seat cushion foam, and then route the sensor harness through the harness opening in the foam.
CAUTIONWhile installing the harness, take care not to damage the foam.
-
Peel the protective backing off of the resistive occupancy sensor, exposing the adhesive, and then install the sensor on top of the foam.
NoteAlign the sensor with the indentations on the foam.
- Install the passenger seat cushion trim. See Trim - Cushion - Driver Seat (Remove and Replace).
-
If servicing the front passenger seat in
a North American vehicle:
- Remove all objects from the front passenger seat before beginning calibration.
- On the vehicle touchscreen, touch Software Reinstall - Touchscreen. If the vehicle firmware is not 2023.2.11 or newer, update the vehicle firmware. See Software Update. and check the vehicle firmware version. If the vehicle firmware is 2023.2.11 or newer, perform a software reinstall. See
- Locally connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect).
- Unlock the vehicle gateway. See Gateway (Unlock).
- In Toolbox, click on the Actions tab, and then search for "OCS".
- Run the PROC_OCS1P_SELF-CALIBRATIONSearch for routine in ToolboxSafety & Restraints / Seats - OCS1P Self Capacitance Calibration routine.
- Click on the Actions tab, and then search for "Seat calibration".
- Run the PROC_VCRIGHT_SEAT-CALIBRATESearch for routine in Toolbox routine.
- Disconnect Toolbox and remove the laptop from the vehicle.