19/02/2024 02:47:00

Trim - Side - Trunk - LH (Remove and Replace)

Correction code 15245002 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-02-19: Added a note about production differences.

Remove

  1. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to remove the 2nd row lower seat cushion in 7-seater vehicles. Tilt the LH 2nd row seat forward instead.
  2. Remove the LH lower C-pillar trim. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  3. Remove the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  4. For 7-seater vehicles, fold the 3rd row seat backs to the down position.
  5. Remove the front trunk load floor. See Trunk Load Floor - Front (Remove and Replace).
  6. Remove the trunk sill trim. See Trim - Sill - Trunk (Remove and Replace).
  7. Remove the LH trunk load floor bracket. See Bracket - Trunk Load Floor - LH (Remove and Replace).
  8. Remove the LH trunk pocket bracket. See Bracket - Trunk Pocket - LH (Remove and Replace).
  9. Release the clips (x6) that attach the top edge of the LH trunk side trim to the vehicle, and then carefully pull back the top edge of the trim.
    Informational PurposesAn informational icon, calling your attention
    Note
    The trim part and the number of clips in the following steps may slightly differ by vehicle build date and location.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not pull the trim too far from the body, as harnesses are still connected to the trim.
    Figure 1. 5-seater
    Figure 2. 7-seater
  10. Reach behind the LH trunk side trim and disconnect the electrical connectors (x3) from the trim.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not touch the terminals at the rear of the auxiliary low voltage connector as they are still powered.
    Informational PurposesAn informational icon, calling your attention
    Note
    7-seater vehicles have 2 connectors.
    Figure 3. 5-seater
    Figure 4. 7-seater
    Figure 5. 7-seater
  11. Release the remaining clips (x6) that attach the LH trunk side trim to the vehicle, and then remove the trim from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    For 7-seater vehicles, guide the front clip stanchions around the LH C-pillar, pull the top of the trunk side trim all the way down flat so that it clears the edge of the folded down LH 3rd row seatback, and then pull the trim straight out.
    Figure 6. 7-seater
    Figure 7. 7-seater

Install

  1. Position the LH trunk side trim into the vehicle, and then install the clips (x5) that attach the lower portion of the trim to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Guide the front clip stanchions around the LH C-pillar.
    Informational PurposesAn informational icon, calling your attention
    Note
    For 7-seater vehicles, start by tucking the lower portion of the trim around the edge of the LH 3rd row seat back.
    Figure 8. 7-seater
    Figure 9. Trunk side trim lower clips
  2. Connect the electrical connectors (x3), and then install the clips (x6) that attach the upper portion of the LH trunk side trim to the vehicle..
    Informational PurposesAn informational icon, calling your attention
    Note
    7-seater vehicles have 2 connectors.
    Figure 10. 5-seater
    Figure 11. 7-seater
    Figure 12. 7-seater
    Figure 13. Trunk side trim upper clips
  3. Install the LH trunk pocket bracket. See Bracket - Trunk Pocket - LH (Remove and Replace).
  4. Install the LH trunk load floor bracket. See Bracket - Trunk Load Floor - LH (Remove and Replace).
  5. Install the trunk sill trim. See Trim - Sill - Trunk (Remove and Replace).
  6. Install the front trunk load floor. See Trunk Load Floor - Front (Remove and Replace).
  7. For 7-seater vehicles, raise the 3rd row seatbacks to the original positions.
  8. Install the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  9. Install the LH lower C-pillar trim. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  10. Install the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).