26/06/2020 08:02:56

Pivot Clamps - Seat Back - 2nd Row - Center/20 (Remove and Replace)

Correction code 13050402 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Pivot Clamps - Seat Back - 2nd Row - Center/20 (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts that attach the center 2nd row seatback pivot clamps to the vehicle
22 Nm (16.2 lbs-ft)
  • Torx T40 socket
  • Flex head ratchet/flex head torque wrench
Reuse

Remove

  1. Open all doors and fully lower all windows.
  2. Move the front seats to their foremost position.
  3. Fold the center 2nd row seatback down.
  4. Fully raise the center 2nd row headrest.
  5. Remove the center 2nd row backrest switch. See Backrest Switch – Seat Back – 2nd Row – Center (Remove and Replace).
  6. Use a trim tool to release the clips that attach the center back panel to the seat, working from the bottom of the seat towards the top, and then remove the panel from seat assembly.
  7. Remove the center 2nd row lumbar bun. See Lumbar Bun - 2nd Row - Center/20 (Remove and Replace).
  8. Remove the bolts that attach the center 2nd row seatback pivot clamps to the vehicle.
    22 Nm (16.2 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T40 socket
    • Flex head ratchet/flex head torque wrench
  9. Slide the center 2nd row seatback pivot clamps toward the center of the seatback, and then pull the clamps outward to remove them from the vehicle.

Install

Installation procedure is the reverse of removal.