03/06/2024 03:16:58

Harness - Jumper for Ethernet - Car Computer (AP4) (Remove and Replace)

Correction code 1710070012 0.60 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Remove the HEPA filter assembly. See Assembly - Filter - HEPA (Remove and Install).
  3. Disconnect the LV battery power. See 12V/LV Power (Disconnect and Connect).
  4. Remove the RH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
  5. Remove the RH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
  6. Remove the passenger footwell cover. See Cover - Footwell - Passenger (LHD) (Remove and Replace).
  7. Remove the glove box. See Glove Box - Without Knee Airbags (Remove and Replace).
  8. Disconnect the harness connectors (x2) on the RH side of the car computer.
  9. Disconnect the upper jumper harness connectors (x2) from the car computer, and then release the clip that attaches the jumper harness to the car computer.
  10. Disconnect the lower jumper harness connectors (x2) from the car computer.
  11. Remove the jumper harness from the vehicle.

Install

Installation procedure is the reverse of removal.