04/09/2024 15:06:15

Reservoir - Windshield Washer (Remove and Replace)

Correction code 17501102 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Remove the LH and RH wiper arms. See Wiper Arms (Remove and Replace).
  3. Remove the cowl screen panel. See Panel - Cowl Screen (Remove and Replace).
  4. Remove the wiper motor. See Wiper Module (Remove and Replace).
  5. Remove the windshield washer system assembly. System - Windshield Washer (Remove and Replace).
  6. Remove the washer hose, washer pump and washer grommet from the reservoir.
    Informational PurposesAn informational icon, calling your attention
    Note
    Inspect the washer pump grommet for damage and replace as necessary.
  7. Use a plastic trim tool to gently pry the washer level sensor from the washer assembly, and then remove the rubber grommet and sensor from the assembly..
    Informational PurposesAn informational icon, calling your attention
    Note
    Inspect the level sensor grommet for damage and replace as necessary.
  8. Remove the windshield washer reservoir.

Install

Installation procedure is the reverse of removal.