2024-12-02

Fan - Camera - Forward Facing (Remove & Replace)

Correction code 17242102 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Fan - Camera - Forward Facing (Remove & Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws that attach the forward facing camera fan
0.12 Nm (1 lbs-in)
  • Torx T6 bit
  • Digital Torque Screwdriver 0.10Nm - 2.0Nm
Reuse

Remove

  1. Remove the upper quad camera cover. See Quad Camera Cover - Upper (Remove and Replace).
  2. Release the screws (x3) that attach the forward facing camera fan, and then remove the forward facing camera fan from the vehicle.
    0.12 Nm (1 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T6 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm

Install

Installation procedure is the reverse of removal.