20/04/2020 11:13:53

Fascia - Rear - Lower (Remove and Replace)

Correction code 10012902 0.84 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Fascia - Rear - Lower (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts that attach the lower rear fascia to the upper rear fascia
3 Nm (2.2 lbs-ft)
  • 10 mm socket
  • 4 in extension
Reuse

Remove

  1. Remove the rear fascia. See Fascia - Rear (Remove and Install).
  2. Remove the bolts (x6) that attach the lower rear fascia to the upper rear fascia.
    3 Nm (2.2 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
    • 4 in extension
  3. Remove the metal clips from the center of lower rear fascia.
  4. Release the tabs (x17) that attach the upper rear fascia to the lower rear fascia, and then separate the upper rear fascia from the lower rear fascia.
  5. Release the clip and tab that attach the LH reflector to the lower rear fascia, and then slide the reflector outward to remove it from the fascia. Repeat this step for the RH side reflector.
    Figure 1. LH shown; RH similar
  6. Release the clips that attach the tow hook cover to the lower rear fascia, and then remove it from the fascia.
  7. Release the clips (x15) that attach the tow hitch cover to the lower rear fascia, and then remove the cover from the fascia.

Install

Installation procedure is the reverse of removal.