2021-06-18
Striker - Door - Rear - LH (Remove and Replace)
Correction code
11354002
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
Install
- Hand-tighten the bolts that attach the LH rear door striker to the body.
- Close the LH rear door and verify the door position; adjust the position of the striker and verify fitment, if necessary.
-
Tighten the bolts that
attach the LH rear door striker to the body.26 Nm (19.2 lbs-ft)TIpUse of the following tool(s) is recommended:
- T45 socket
- Remove the masking tape from the body.
- Close the LH rear door.