24/02/2023 14:50:45

Harness - Backrest - 2nd Row Seat - RH (7-Seat) (Remove and Replace)

Correction code 17100142 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the RH doors and lower the RH windows.
  2. Move the RH front seat fully forward.
  3. Fold the RH 2nd row seat to the down position.
  4. Use the towel bar to move the RH 2nd row seat forward.
  5. Remove the RH 2nd row seat back panel. See Back Panel – 2nd Row Seat – RH (Remove and Replace).
  6. Remove the RH 2nd row seat shoulder switch. See Shoulder Switch – Seat Back – 2nd Row – LH (Remove and Replace).
  7. Remove the RH 2nd row toe kick cover. See Cover - Toe Kick - 2nd Row Seat - RH (7-Seat) (Remove and Replace).
  8. Release the clips (x2) that attach the RH 2nd row seat backrest harness to the bottom side of the seat frame, disconnect the connector, and then remove the seat harness from the seat assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove the elastic harness holder to the release harness.
  9. Disconnect the RH 2nd row seat heater connector.
  10. Release the clip that attaches the RH 2nd row seat heater connector to the seat assembly.
  11. Release the fir tree clips (x2), and then release the shoulder switch harness from the harness guides (x5) on the upholstery support.
  12. Use a pry tool to release the shoulder switch connection from between the seatback and seat frame, and then remove the harness from the seat assembly.

Install

  1. Use a pry tool to insert the shoulder switch connection between the seatback and seat frame, and then route the harness onto the seat assembly.
  2. Secure the fir tree clips (x2), and then secure the shoulder switch harness to the harness guides (x5) on the upholstery support.
  3. Install the clip that attaches the RH 2nd row seat heater connector to the seat assembly.
  4. Connect the RH 2nd row seat heater connector.
  5. Secure the clips (x2) that attach the RH 2nd row seat backrest harness to the bottom side of the seat frame, and then connect the connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Install the plastic harness retainer.
  6. Install the RH 2nd row toe kick cover. See Cover - Toe Kick - 2nd Row Seat - RH (7-Seat) (Remove and Replace).
  7. Install the RH 2nd row seat shoulder switch. See Shoulder Switch – Seat Back – 2nd Row – LH (Remove and Replace).
  8. Install the RH 2nd row seat back panel. See Back Panel – 2nd Row Seat – RH (Remove and Replace).
  9. Fold the RH 2nd row seat to the up position.
  10. Move the RH front seat to the original position.
  11. Raise the RH windows and close the RH doors.