11/01/2023 23:19:55

Ambient Light Module - Front Door Trim - LH (Remove and Replace)

Correction code 17356102 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the front LH door, and fully lower the window.
  2. Remove the LH front door tweeter. See Tweeter - Front Door - LH (Remove and Replace).
  3. Remove the LH front door puddle light. See Puddle Light - Front Door - LH (Remove and Replace).
  4. Remove the LH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Install).
  5. Remove the LH front door NVH pad. See NVH Pad - Door - Front - LH (Remove and Replace).
  6. Remove the connector (x1) from the trim panel and release the ambient module from the clips (x2).
  7. Apply maksing tape around the work area to protect the trim panel.
  8. Use a plastic trim tool to gently remove the bolt cover from the trim panel.
  9. Gently pry the tab to remove the ambient module from the bolt cover.

Install

  1. Install the ambient module to the bolt cover.
  2. Install the bolt cover to the trim panel.
  3. Remove the masking tape from the trim panel.
  4. Install the connector (x1) to the trim panel.
  5. Install the LH front door NVH pad. See NVH Pad - Door - Front - LH (Remove and Replace).
  6. Install the LH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Install).
  7. Install the LH front door puddle light. See Puddle Light - Front Door - LH (Remove and Replace).
  8. Install the LH front door tweeter. See Tweeter - Front Door - LH (Remove and Replace).
  9. Raise the window and close the door.