09/10/2023 19:58:21

Bracket - Rear - Center (Remove and Replace)

Correction code 10014302 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2023-10-09: Updated the reference for removing the rear fascia assembly.

Torque Specifications

Table 1. Torque Specifications: Bracket - Rear - Center (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts that attach the rear center bracket to the body
4 Nm (2.9 lbs-ft)
  • 10 mm socket
  • 4 in extension
 Reuse

Remove

  1. Remove the rear fascia. See Fascia - Rear (Remove and Install).
  2. Disconnect the electrical wiring harness connector from the rear Bluetooth passive entry module.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not push down on the red tab. Instead, pull the red tab to disengage the lock and then pull again to release the connector.
  3. Remove the bolt and release the clip that attach the Bluetooth passive entry module to the body, and then remove the module from the bracket.
    Informational PurposesAn informational icon, calling your attention
    Note
    When releasing the module from the bracket, rotate the left side away from the bracket to release the tab.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • 4 in extension
  4. Release the clips that attach the electrical harness to the rear center bracket assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    The end clip is hidden by the electrical connector.
  5. Remove the bolts that attach the rear center bracket to the body.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • 4 in extension
  6. Release the tabs that attach each end of the rear center bracket to the body.
    Tip: Assistance may be required to perform this step.
  7. Remove the rear center bracket from the vehicle.

Install

  1. Position the rear center bracket on the vehicle, and then install the tabs that attach each end of the rear center bracket to the body.
    Tip: Assistance may be required to hold the bracket in place when performing this step.
  2. Install the bolts that attach the rear center bracket to the body.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • 4 in extension
  3. Install the clips that attach the rear Bluetooth passive entry antenna electrical harness to the rear center bracket.
  4. Install the bolt that attaches the Bluetooth passive entry module to the body.
    3.5 Nm (2.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • 4 in extension
  5. Connect the electrical wiring harness connector to the rear Bluetooth passive entry module.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Make sure the red locking tab is fully engaged.
  6. Install the rear fascia. See Fascia - Rear (Remove and Install).