31/05/2024 04:37:30

Drip Guard - Car Computer (HW4) (Remove and Replace)

Correction code 2110022012 0.66 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the RH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
  2. Remove the RH mid A-pillar assembly. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  3. Remove the RH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
  4. Remove the RH footwell cover. See Cover - Footwell - Passenger (LHD) (Remove and Replace).
  5. Remove the main instrument panel decor trim. See Decor Trim - Instrument Panel - Main (Remove and Replace).
  6. Remove the glove box. See Glove Box - Without Knee Airbags (Remove and Replace).
  7. Release the tabs (x3), and then remove the drip guard assembly from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull on the drip guard assembly, then tilt it in front of the car computer to remove it.

Install

Installation procedure is the reverse of removal.