Sensor - Brake Fluid Reservoir Level (Remove and Replace)
     Correction code
    
                           33200012
                           0.06
                           
        
          NOTE: Unless otherwise explicitly
          stated in the procedure, the above correction code and FRT reflect all of the work
          required to perform this procedure, including the linked procedures. Do not stack correction codes unless
            explicitly told to do so.
        
          NOTE: See Flat Rate
            Times to learn more about FRTs and how they are created. To provide feedback on
          FRT values, email ServiceManualFeedback@tesla.com. 
        
          NOTE: See Personal Protection to make sure wearing proper PPE when
          performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
    Correction code
    
                           33200012
                           0.06
                           
        
          NOTE: Unless otherwise explicitly
          stated in the procedure, the above correction code and FRT reflect all of the work
          required to perform this procedure, including the linked procedures. Do not stack correction codes unless
            explicitly told to do so.
        
          NOTE: See Flat Rate
            Times to learn more about FRTs and how they are created. To provide feedback on
          FRT values, email ServiceManualFeedback@tesla.com. 
        
          NOTE: See Personal Protection to make sure wearing proper PPE when
          performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
      
                        
  
Remove
- Open the LH front door and fully lower the LH front window.
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
- 
          Disconnect the brake fluid reservoir level sensor.
          NoteSlide the locking tab away from the connector to fully release it.
- 
          Release the clip that attach the brake fluid reservoir level sensor to the
                        brake fluid reservoir, and then remove the sensor from the vehicle.
          
Install
Installation procedure is the reverse of removal.