17/10/2022 10:09:38

Duct - Floor - 2nd Row - RH (Structural Pack) (Remove and Replace)

Correction code 18109812 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the RH front door.
  2. Move the front passenger seat rearward.
  3. Remove the RH front floormat.
  4. Remove the RH mid A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  5. Remove the RH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
  6. Remove the RH center console side panel. See Side Panel - Center Console - LH (Remove and Replace).
  7. Remove the passenger footwell cover. See Cover - Footwell - Passenger (LHD) (Remove and Replace).
  8. Release the clips (x2) that attach the RH front cabin carpet to the cabin support.
  9. Release the seat harness clip, route the harness away from the carpet, and then fold the RH front cabin carpet rearward.
  10. Release the RH 2nd row floor duct from the main duct, and then pull the RH duct toward the front of the vehicle to remove it.

Install

  1. Position the RH 2nd row floor duct into the vehicle, push the duct toward the rear of the vehicle, and then secure the RH duct to the main duct.
  2. Fold the RH front cabin carpet to the original position, maneuver the seat harness to the carpet, and then secure the harness clip.
  3. Install the clips (x2) that attach the RH front cabin carpet to the cabin support.
    Informational PurposesAn informational icon, calling your attention
    Note
    Verify fitment of the carpet.
  4. Install the passenger footwell cover. See Cover - Footwell - Passenger (LHD) (Remove and Replace).
  5. Install the RH center console side panel. See Side Panel - Center Console - LH (Remove and Replace).
  6. Install the RH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
  7. Install the RH mid A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  8. Move the front passenger seat to the original position.
  9. Install the RH front floormat.
  10. Close the RH front door.