19/10/2023 01:03:54

Steering Wheel (Remove and Install)

Correction code 32051801 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2023-10-12: Added the removal/installation of HEPA filter assembly.

Torque Specifications

Table 1. Torque Specifications: Steering Wheel (Remove and Install)
Description Torque Value Recommended Tools Reuse/Replace Notes
Steering wheel to steering column bolt
80 Nm (59.0 lbs-ft)
  • 10 mm hex
  • 3/8 in std ratchet
  • 3/8 in flex head torque wrench (installation only)
  • 3 in extension
Replace PN - 1036655-00-A

Remove

  1. Set the vehicle's front wheels straight and the steering wheel centered.
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Remove the HEPA filter assembly. See Assembly - Filter - HEPA (Remove and Install).
  4. Disconnect LV power. See 12V/LV Power (Disconnect and Connect).
  5. Remove the driver airbag. See Airbag - Driver (Remove and Replace).
  6. Disconnect the steering wheel electrical wiring harness connector.
  7. Remove and discard the bolt that attaches the steering wheel to the steering column.
    80 Nm (59.0 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm hex
    • 3/8 in std ratchet
    • 3/8 in flex head torque wrench (installation only)
    • 3 in extension
  8. Remove the steering wheel from the steering column.

Install

  1. Position the steering wheel into the vehicle, and then install a new bolt that attaches the steering wheel to the steering column.
    80 Nm (59.0 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm hex
    • 3/8 in std ratchet
    • 3/8 in flex head torque wrench (installation only)
    • 3 in extension
  2. Connect the steering wheel electrical wiring harness connector.
  3. Install the driver airbag. See Airbag - Driver (Remove and Replace).
  4. Reconnect LV power. See 12V/LV Power (Disconnect and Connect).
  5. Install the HEPA filter assembly. See Assembly - Filter - HEPA (Remove and Install).
  6. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).