18/10/2024 14:55:11

Overhead Console - Front (Remove and Replace)

Correction code 15202302 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.0.10

  • 24-03-24: Correct installation step 4 (EMEA): from "Autodiag" to "Actions"
  • 24-03-28: Added step to disable service mode to verify proper function of the microphone.

Remove

  1. Release the clips (x2) that attach the front overhead console to the headliner, and then lower the console from the headliner.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    To avoid damaging the headliner, do not pry against the headliner. Insert a 90 degree trim tool near the dome light and pull downwards to release the clip, and then move to the other side to release the remaining clip.
  2. Disconnect the electrical connector from the front overhead console.
  3. Remove the front overhead console from the headliner.

Install

  1. Connect the front overhead console electrical connector.
  2. Push the front overhead console upwards into the headliner and engage the clips (x2)
  3. Reinstall the vehicle firmware. See Software Reinstall - Touchscreen.