08/05/2020 15:55:56

Bumper Beam - Rear (Remove and Replace)

Correction code 10013102 0.90 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Bumper Beam - Rear (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Nuts that attach the rear bumper beam to the body
62.5 Nm (46.1 lbs-ft)
  • 15 mm deep socket
  • 6 in extension
 Reuse

Remove

  1. Remove the rear center bracket. See Bracket - Rear - Center (Remove and Replace).
  2. Remove the nuts that attach the rear bumper beam to the body, and then remove the rear bumper beam from the vehicle.
    Tip: Recommend assistance when performing this step.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 15 mm deep socket
    • 6 in extension

Install

  1. Position the rear bumper beam on the body, and then install the nuts that attach the rear bumper beam to the body.
    62.5 Nm (46.1 lbs-ft)
    Tip: Recommend assistance when performing this step.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 15 mm deep socket
    • 6 in extension
  2. Install the rear center bracket. See Bracket - Rear - Center (Remove and Replace).