14/08/2020 13:32:09

Carpet - Rear (Remove and Replace)

Correction code 15303202 0.90 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open all doors.
  2. Fully lower all windows.
  3. Remove the LH and RH middle A-pillar trims. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  4. Remove the LH and RH lower A-pillar trims. See Trim - A-Pillar - Lower - LH (Remove and Replace).
  5. Remove the driver and front passenger seats. See Seat Assembly - 1st Row - LH (Remove and Replace).
  6. Remove the center console. See Center Console (Remove and Install).
  7. Remove the LH and RH lower B-pillar trims. See Trim - B-Pillar - Lower - LH (Non-Structural Pack) (Remove and Replace).
  8. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  9. Remove the LH and RH lower C-pillar trims. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  10. Remove the 2nd row floor mat from the vehicle.
  11. Release the clips that attach the main carpet to the lower seat cushion frames.
  12. Remove the rear carpet from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull up at the rear of the rear main carpet, and then slide the carpet back to remove it through the LH rear door.

Install

Installation procedure is the reverse of removal.