29/05/2024 05:45:43

Brake Pad Kit - Front - Hitachi (Remove and Replace)

Correction code 33018002 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Informational PurposesAn informational icon, calling your attention
Note
For detailed brake specifications, see Brakes.

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Remove the LH front wheel. See Wheel Assembly (Remove and Install).
  4. Remove and discard the bolts that attach the LH front brake caliper to the LH front knuckle.
  5. Use a brake caliper S-hook to hang the LH front caliper on the body.
  6. Pull the clips off the caliper rib at the top and bottom of pads.
  7. Clean the LH caliper bracket with a wire brush.
  8. Repeat step 3 through step 7 to remove the RH front brake pads.

Install

  1. Install the LH front brake pads on the LH front brake caliper.
    Tip: Push the pads toward the anti rattle springs, and then slide the pads onto the fixed pins.
  2. Position the LH front brake caliper onto the LH front knuckle, install new bolts that attach the caliper to the knuckle, and then mark the bolt with a paint pen.
    32 Nm (23.6 lbs-ft)
  3. Install the LH front wheel. See Wheel Assembly (Remove and Install).
  4. Repeat step 1 through step 3 to install the RH front brake pads.
  5. Lower the vehicle.
  6. Pump the brake pedal to seat the pads against the brake rotor until the brake pedal feels firm.
  7. Check the brake fluid reservoir and top off as necessary.
  8. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  9. Perform a road test and burnish the brake pads. See Brake Pads - Burnishing.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure proper brake pedal feel and brake performance.
    Informational PurposesAn informational icon, calling your attention
    Note
    Add correction code 33013000 as a separate activity to the SV.