2026-09-25

Buckle - 2nd Row - LH (7 Seat) (Remove and Replace)

Correction code 20057022 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2024-11-26: Add a note to clarify that harness should not be around bolt when install the buckle to seat assembly.
CAUTION
Supplemental Restraint System (SRS) components can be hazardous if not serviced and handled correctly. See
CAUTION
In the event of an airbag or seatbelt pretensioner deployment, certain components must be replaced, and other components must be inspected for damage. Refer to the Collision Repair Manual for a specific list of items that must be inspected and replaced.

Remove

  1. Open the LH rear door.
  2. Move the LH 2nd row seat back assembly forward.
    Note
    Press the EZ entry button, slide the seat forward, release the button, and then lift the seat upward.
  3. Disconnect LH 2nd row buckle connector, and then release the clip that attaches the connect to the vehicle.
  4. Remove and discard the bolt that attaches the LH 2nd row buckle to the seat frame, and then remove the buckle from the vehicle.
    40 Nm (29.5 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 15 mm socket

Install

  1. Position the LH 2nd row buckle into the LH 2nd row seat, and then install a new bolt that attaches the buckle to the seat frame.
    40 Nm (29.5 lbs-ft)
    Note
    Make sure to not pinch the wire between the bolt and the buckle bracket. Harness should not be around bolt.
    Tip
    Use of the following tool(s) is recommended:
    • 15 mm socket
  2. Secure the LH 2nd row buckle connector to the seat, and then connect the electrical connector.
  3. Move the LH 2nd row seat back assembly to the original position.