Bracket - License Plate - Front (Remove and Replace)
Correction code
12070102
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created.
NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure. NOTE: See Ergonomic Precautions for safe and healthy working
practices.
- 2026-05-08: Updated the adhesive clean process.
Equipment:
- 1049517-00-A ERGONOMIC SILICONE SEAM ROLLER
Remove
-
Remove the screws that
attach the front license plate to the front fascia, and then remove the
license plate.
-
Use alcohol wipes to clean any bracket tape, residue, or debris from the
front fascia.
Install
-
Install the license plate
onto the front license plate bracket, and install the screws that attach the
plate to the front fascia.
3 Nm (2.2 lbs-ft)