05/05/2020 11:40:22

Trim - A-Pillar - Lower - LH (Remove and Replace)

Correction code 15182402 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the LH front door.
  2. Remove the LH middle A-Pillar trim panel. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  3. Release the topmost clip on the LH lower A-pillar trim.
  4. Pull the rearmost part of the LH lower A-pillar trim upward to release the clips and tabs, and then pull the entire trim rearward to remove the trim from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove any remaining LH lower A-pillar trim clips from the LH A-pillar and sill, and if the LH lower A-pillar trim is to be later installed, remove all clips from the trim.

Install

Installation procedure is the reverse of removal, except for the following:

  • If reusing the same LH lower A-pillar trim, install new clips onto the trim.
  • Make sure that the tabs at the front of the trim engage properly, and that the trim fits tight against the A-pillar.
  • Make sure that the door seal overlaps the LH lower A-pillar trim.