2021-04-22

Antenna Amplifier - FM2 (Remove and Replace)

Correction code 21300702 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the liftgate upper trim. See Trim - Upper - Liftgate (Remove and Replace).
  2. Disconnect the FM2 antenna amplifier electrical connectors.
  3. Remove the bolt that attaches the FM2 antenna amplifier to the liftgate, and then remove the amplifier from the assembly.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • Flex head ratchet/flex head torque wrench

Install

  1. Position the FM2 antenna amplifier onto the liftgate, and then install the bolt.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • Flex head ratchet/flex head torque wrench
  2. Connect the FM2 antenna amplifier electrical connectors.
  3. Install the liftgate upper trim. See Trim - Upper - Liftgate (Remove and Replace).