17/10/2022 13:57:14

Hinge - Door - Rear - Upper - LH (Structural Pack) (Rework)

Correction code 11336803 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the front LH door.
  2. Lower the LH front window.
  3. Apply tape to the LH rear door and body side upper hinge location.
    Informational PurposesAn informational icon, calling your attention
    Note
    This will mark where the hinge should align during installation.
  4. Remove the bolts (x2) that attach the LH upper rear door hinge to the body.
    24 Nm (17.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 13 mm socket
  5. Partially open the LH front door. With an assistant, partially open the LH rear door, and then pull the hinge away from the body. Move the hinge outwards to gain access to the guided pins.
  6. Close the LH rear door.
  7. Remove the guided pins.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove the guided pins (x2) out of LH rear upper door hinge using locking pliers (1115178-00-A or similar).
    Informational PurposesAn informational icon, calling your attention
    Note
    Rotate the pins during removal.

Install

  1. Install the hinge to the body.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not damage the vehicle paint.
  2. Hand-tighten the bolts (x2) that attach the hinge to the body.
  3. Close the LH front door.
  4. Check the gap and flushness of the LH rear door.
    Informational PurposesAn informational icon, calling your attention
    Note
    Adjust the LH rear door if necessary. Refer to CVIS for current specifications.
  5. Open the LH front door.
  6. Tighten the bolt and nut that attach the hinge to the door, if loosened for door adjustment.
    49 Nm (36.1 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 13 mm socket
  7. Tighten the bolts (x2) that attach the hinge to the body.
    24 Nm (17.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 13 mm socket
  8. Remove the tape from the LH body side and door side of the upper hinge location.
  9. Apply touch-up paint to the hinge bolts.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure to shake the touch-up paint before applying,
    Informational PurposesAn informational icon, calling your attention
    Note
    Allow 1st coat to dry for 20 minutes before applying 2nd coat, if needed.
  10. Raise the LH front window.
  11. Close the LH front door.