28/02/2023 13:13:02

Harness - Front Subframe (Remove and Replace)

Correction code 17107102 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Open the LH front door and lower the LH front window.
  3. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  4. Disconnect LV power. See 12V/LV Power (Disconnect and Connect).
  5. Remove the front aero shield panel. See Panel - Aero Shield - Front (Non-Structural Pack) (Remove and Replace).
  6. Release the connector lock from the opposite side of the LH front rail bracket, and then disconnect the front subframe harness towards the front of the vehicle.
  7. Release the locking tab, disconnect the front drive unit inverter logic connector, and then release the harness clips (x2).
  8. Release the clips (x3) that attach the front drive unit harness clips on the LH side of the front subframe.
  9. Release the clips (x2) that attach the front drive unit harness in front of the front subframe.
  10. Release the clips (x3) that attach the front drive unit harness on the RH side of the front subframe.
  11. Release the locking tab, disconnect the resolver logic connector, and then release the harness clip.
  12. Release the connector lock, and then disconnect the oil pump connector.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    DO NOT push down on the red locking tab. Pull the tab away from the connector until the connector is unlocked, and then continue pulling to release the connector.
  13. Remove the front drive unit harness from the front subframe.

Install

  1. Position the front drive unit harness into the front subframe.
  2. Connect the resolver logic connector, engage the locking tab, and then secure the harness clip.
  3. Connect the oil pump connector, and then engage the locking tab.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Push the red locking tab towards the connector to engage the locking mechanism. DO NOT push down or pull up on the red locking tab.
  4. Secure the clips (x3) that attach the front drive unit harness on the RH side of the front subframe.
  5. Secure the clips (x2) that attach the front drive unit harness in front of the front subframe.
  6. Secure the clips (x3) that attach the front drive unit harness clips on the LH side of the front subframe.
  7. Connect the front drive unit inverter logic connector, engage the locking tab, and then install the harness clips (x2).
  8. Connect the harness connector located at the LH front of the rail bracket, and then engage the locking tab.
  9. Install the front aero shield panel. See Panel - Aero Shield - Front (Non-Structural Pack) (Remove and Replace).
  10. Remove the vehicle from the lift. See Raise Vehicle - 2 Post Lift.
  11. Connect LV power. See 12V/LV Power (Disconnect and Connect).
  12. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  13. Raise the LH front window and close the LH front door.